See this product in video click on the following link: https://youtu.be/HP4bDwBWSEE

HS10PWM 10-Channel Remote Control Receiver transmitter robot DIY Smart Car Robot Remote Control Module


Remote control working voltage: DC 2.8v-3.3v (please use two 1.5v 5 batteries for installation)


Receiving main board working input voltage range: DC 6V-12V (please use power-type lithium battery, select the suitable power supply device according to the voltage and power of the motor)


Measured remote control distance: 30-50m


This remote control comes with proportional speed control function
Can control 4 speed-regulating motors and a forward and reverse motor


Specification for Remote Controller:
- Item name:10CH 2.4G remote controller 
- Remote controller working voltage: DC 2.8V-3.3V
- The remote controller need 2pcs 1.5V AA battery, will not include in package
- USB charging cable,PLS use output voltage DC 5V output current 2000mah(2A) charger 
- After added the signal booster,then the controlling distance can be reach to 500 meters
- Receiver board working voltage: DC 6V-12V
 
Specification for Signal Booster: 
- Working voltage: DC 2.8V-4.2V
- Charging voltage: DC 4.6V
- Working current: 80-120mah
- Working frequency: 2.4GHZ
- Transmit frequency: 14dbm
- Size: 160x36x18mm
- Measured distance: about 500 meters to 800 meters , (actual test distance at 60 m wide city road in sunny    weather) 
- Communication Interface: SMA-JE
- Antenna interface: SMA-KE
- Antenna type: outside SMA inner pin high gain (3.0 dbi) antenna
- Charging time: about 1 hour
- Working time: about 1.5 hours 
 
 Tips for safe use against overvoltage and overload (please read carefully)
- Receiving board operating voltage range: DC6V-12V, input voltage and output voltage are the same, each single channel output maximum peak current 7A, sustainable load current 4A
 
Note: when selecting the motor, do not only look at the no-load current, but must recognize the motor's operating voltage and load current or stalled current. Only the motor's operating voltage and load current or stalled current can be used within the voltage and current parameters specified by the receiving board. Do not be ignorant of installation and blind use, mismatching after use will cause excessive current damage to the receiving motherboard, high-power motor and high-speed motor please use with caution!If the motor rotation after receiving plate drive IC hot, or with the motor rotation or motor rotation is very slow, you can not press the remote control to let it turn!When the motor is locked up, the current is maximum and IC is easily burned.
 
Description:
- Operating voltage range of receiving board: DC6V-12V, output voltage per channel = power input voltage, output maximum peak current 7A per channel, sustainable load current 4A, excessive load will burn the board!Please use lithium battery as the power supply, each output of the receiving board can only be connected to the carbon brush motor, Output 1 control the positive and negative motor rotation function, output 2~output 5 is PWM proportional speed regulation, adjust the output voltage of the receiving board from low to high through the remote control potentiometer push stick throttle, control output 2~output 5 positive and negative motor rotation and speed
 
 Package include:
1pcs x Remote Controller 
1pcs x Receiver Board