3D Printer Controller Board Shield for RAMPS 1.6 Upgrade Base On Ramp 1.4 1.6


he RAMPS 1.6 is the second RAMPS iteration released by BIQU/BIGTREETECH. It replaces the original green power connector with a pair of screw terminals, adds a larger heatsink over the MOSFETS, and has a larger bed MOSFET. It maintains the surface-mounted fuses and flush MOSFETS of the RAMPS 1.5.


Also, the positions of the D1 and D2 diodes have been swapped from the positions in RAMPS 1.4, the D1 diode is now the diode closest to fuse F2. The same is true for RAMPS 1.5, also manufactured by BIQU/BIGTREETECH.


1.It can be connected to LCD and other parts.
2.There are heater and fan MOSFET outputs and 3 thermistor interfaces
3.5A additional security and component protection fusion
4.Heated bed controls additional 11A fuses
5.Applied to 5 Pololu stepper drive board
6.Design of Pololu plate pin socket can be easily replaced or removed for future design
7.I2C and SPI pins are available for future expansion
8.Servo connectors are used for connecting limit stops, motors and light-emitting diodes.
These connectors are gold-plated and have a rated current of 3A, which is very compact.
9.The LED will light when the heater has output
10.Support 2 motors to connect to Z Prusa Mendel


Ramps 1.6 is optimized and launched based on Ramps 1.4 & Ramps 1.5
The Struture almost same as Ramps 1.5,
the difference is Ramps 1.6 have new 2pin connectors,
which more simple and convenient to connect,
also will not be burnt easily, what's more,
Ramps 1.6 have a good Heatsink above MOS tube
in order to give a better function to heat dissipation
Beside, the Power of Ramps 1.6 is more larger than Ramps 1.5,
the largest power will be up to or 270W,
and Ramps 1.5 just can be up to 200W, or samller than 200W
Support motor drivers: support A4988 and DRV8825 and other motor drivers
(support up to five motor drivers simultaneously)


Size: about 101.5x 60.5mm
 
Package includes: 
1pcs RAMPS 1.6 Shield
Jumpers